DCCTools :: Knowledgebase
Search:     Advanced search

TechTOOLS Memory Card update error is received

Article ID: 462
Last updated: 24 Feb, 2014

DESCRIPTION

The following memory cards are used with the DRBIII (Diagnostics Readout Box):

  • Supercard 1
  • Supercard 2
  • Sebring Stratus 2 Door (ST22)
  • Dodge Sprinter NAFTA
  • Crossfire

If error message is received while updating any of the above cards then the following troubleshooting steps should be followed:

  1. Remove and re-insert Memory Card from DRBIII
  2. Insure write-protect switch on card is set to Un-Protected (Off) position (See picture below)
  3. Redo Memory Card update
Article ID: 462
Last updated: 24 Feb, 2014
Revision: 1
Views: 2782
Comments: 0
Posted: 24 Feb, 2014 by Maynard R.
Updated: 24 Feb, 2014 by Maynard R.
This article was:   Helpful | Not helpful
Prev   Next
TechTOOLs Reads "DRB III Not Connected"     Co-Pilot Troubleshooting Steps