DCCTools :: Knowledgebase
Search:     Advanced search
General Flash Information
 
document Finding Aftermarket equipment on vehicles
DESCRIPTION ECU Flash Reprogramming and Diagnostic Routine failures have been known to be caused by aftermarket equipment installed on a vehicle. If an ECU flash reprogramming session or routine fails repeatable and all procedures in DealerCONNECT have been followed check for aftermarket...
20 Mar, 2014 Views: 3921 Comments: 0
document Instructional Guide: Flashing with StarSCAN or StarMOBILE
Please see the attached PDF document for a guide on how to flash using StarSCAN or StarMOBILE.
15 Oct, 2013 Views: 5780 Comments: 0
document PCM Has Been Replaced – What To Do Next?
After PCM replacement, there are some simple steps to follow using the wiTECH Diagnostic Application to properly connect to the vehicle:   Open the wiTECH Diagnostic Application, select your device in the Connection Wizard, and click on Next. Log into DealerCONNECT. In a few...
07 Oct, 2013 Views: 26977 Comments: 0
document ECU Flash Failure: What to do Next?
When the initial attempt to perform an ECU Flash fails, the following steps should resolve the issue:     Read all available service documentation (SBs, RRTs, Recalls) from the wiTECH Diagnostic Application to ensure that the flash applies to the connected...
11 Oct, 2013 Views: 19497 Comments: 0
document Flash Reprogramming ECUs Using a Portable Laptop PC
DESCRIPTION: Laptops are usually set to a default Power Scheme that controls how long the computer must be idle/inactive before turning off the monitor, sleeping, standby, or shutting down. In Windows 7, the default power setting is Balanced These modes are triggered...
15 Apr, 2015 Views: 32458 Comments: 0
document wiTECH ECU Flash Warranty Information - Warranty Bulletin D-09-12 and Labor Operation (LOP) Questions
All available service documentation (SB's, RRT's, Recalls) must still be reviewed to confirm that the flash is applicable to the vehicle BEFORE flashing to ensure that the available flash applies to the connected vehicle.  If a flash is not applicable to the connected vehicle, it could damage...
26 Jun, 2013 Views: 6246 Comments: 0
document wiTECH "New Flash Available" Icon Functionality
The purpose of this article is to explain the "New Flash Available" icon's functionality and how it relates to service documentation (Service Bulletins, Safety Recalls, and Rapid Response Transmittals). The wiTECH system does additional filtering to only enable the "New...
15 Oct, 2013 Views: 6508 Comments: 0
document Chrysler Scan Tool Flash Availability Document
See the "Chrysler Scan Tool Flash Availability" PDF attached below.
13 Oct, 2017 Views: 88215 Comments: 0